Anyone know the hex nut wrench size for larrivee endpin?

[campfirehero]

I'm getting ready to install a fishman rare earth humbucking pickup in my Larrivee L-03R, but I don't have the right size allen wrench here at the house. Anyone know the size off hand?

Thanks!

[ronmac]

Use the truss rod tool to remove, it's the same size.

[eded]

Or hit the hardware store and get one of the foldout multi-wrench things or a set.  Around $10 and you are pretty well set for life as far as Allen Wrenches go.  That way, you aren't stuck the next time you need one.

Ed

[knowspicker]

I used a Torx T-30 and fit perfectly.

[campfirehero]

my truss rod tool isn't the right size, I already tried that before posting, have to check out those multi wrench sets, I imagine it's a metric set being Canadian made...

[ronmac]

I just went to the workshop and pulled out my metric/imperial set of wrenches. 3/16" hex is correct size to use.

[AtlasHeating]

I installed the Fishman rare earth blend in my Om 03R. Great for fingerstyle.
When I strum I have to turn off the mic because of the "swish" of my strumming arm.
It was extremely easy because of the pre drilled hole.

[campfirehero]

Thanks, got it installed! Nice pickup and it's great the hole was already pre-drilled to fit the pickup, what a nice extra that Larrivee does when building them..

[AtlasHeating]

You can always remove the pickup and get the guitar back to original