Pages: [1]   Go Down
  Print  
Author Topic: a question about installing a Taylor/Larivee end pin.......  (Read 398 times)
rlouie
Member
**
Offline Offline

Posts: 63




Ignore
« on: January 24, 2009, 10:43:29 PM »

so how do I install the anchor to the Taylor/Larivee end pin??????
do I tap it in with a rubber mallet or something??? it looks like it's got teeth to that sinks into the wood......is that what stabilizes it???????  any info would be appreciated........by the way I did some damage to the hole when I drilled it out, it chipped a bit so I'm trying different end pins trying to cover the damage 




Logged
jeremy3220
Gold Member
****
Offline Offline

Posts: 4598




Ignore
« Reply #1 on: January 24, 2009, 11:08:51 PM »

It works just like a T-nut. The little barbs hold the nut in place while you tighten the bolt. The nut goes on the inside you can't tap it with a mallet or anything; just tighten the bolt.
Logged

rlouie
Member
**
Offline Offline

Posts: 63




Ignore
« Reply #2 on: January 24, 2009, 11:13:28 PM »

so the nut with the barbed teeth go on the inside of the guitar and I screw the end pin in from the outside?????   I get it now.....thanks Jeremy!!!!!!   glad I didn't try to mallet it in fro  the outside!!!!!!!!!!   that would have been even more damage............................ 
Logged
Pages: [1]   Go Up
  Print  
 
Jump to: