About finished?(New QUestion)

[stuco]

 

OK, Maybe unclrob could answer me this one.  I just got my guitar yesterday but I've noticed an annoying run in the satin finish neck.  The finish is just a little bit thicker right in this one spot and there are run lines too. I feel it everytime I'm moving up th neck(quality control, larrivee)  Besides this the guitar is pretty well executed I must say. well this and the rought frets. (Maybe that's how they like them up there in Canada Eh?) Just kidding. but I was thinking this finish problem would be an easy fiix.  Couldn't I just simply use some very very very light sand paper on it and the finish end up with the same consistency?  What grit of sandpaper should I use?  These runny spots are actually glossy if you can believe it from the buildup.  Let me know if you think I better take it to a luthier to do this. 

[unclrob]

NO sandpaper.Get to a hardware store and buy some 0000 steelwool.This a very fine steelwool and willnot remove a lot of finish but should smooth over the spot.In the infected area stroke up and down passing both ends.10 or 15 strokes at a time then feel your neck.Do this with medium pressure.Reaply as needed.As always you can give me a call and I'll talk you through it.If the thought of this give's  you the wiilies please see a good tech.

[stuco]

 

Cool, great advice. I will try it.
Thanks unclrob

[stuco]

 

Thanks for the advice unclrob, I just buffed out the imperfections and am very satisfied with the results.  I think the 0000 steel wool was less abrasive than what they finished the neck with because it gave it a tiny bit of glossiness when I did this.  Anyway thanks.

[LittleBrother]

NO sandpaper.Get to a hardware store and buy some 0000 steelwool.This a very fine steelwool and willnot remove a lot of finish but should smooth over the spot.In the infected area stroke up and down passing both ends.10 or 15 strokes at a time then feel your neck.Do this with medium pressure.Reaply as needed.As always you can give me a call and I'll talk you through it.If the thought of this give's you the wiilies please see a good tech.

+1 +1 :)

[stuco]

 

Ok, got the finish straight but now it has a large glossy area and my hand sticks on it.  How do I get it back to the original more satin  feel?  If at all possible.

[stuco]

 

bump for new question located in the previous post. thanks

[unclrob]

You could try a little 000 steel wool with a very,very light touch.I would do a small area to test.

[stuco]

 

What do they use to finish sanding a satin neck at the factory? (if anyone knows)

[PortHueneme]

My luthier told me about Micro-Fiber. It was developed by the Air Force to polish scratches out of fighter canopy's.
It comes in very fine grits 6,000, 8,000 and even 12,000. I have used it successfully on minor scratches and dings.
I also used it to remove scratches from my watch crystal. It is more like a cloth than a paper, you can use it wet or dry.

After you smooth out the neck apply some pure carnuba, you will slide with ease. The carnuba should be a paste with NO silicons.
I apply the carnuba as needed on the nech as it sweats or rubs off.

good luck