Main Forums => Larrivée Guitars => Topic started by: BongoSTL on October 12, 2005, 03:52:23 PM

Title: Problem/Question...?
Post by: BongoSTL on October 12, 2005, 03:52:23 PM
So i just got my new (used) om-01 in the mail....

great guitar---two problems that i wanted input on.

I noticed that the neck is seperated from the body at the heel...JUST enough so that I can slide a piece of VERY thin paper in about 1/2 a centameter....  anything to worry about, or just no big deal?

Also, I notcied that on the BACK, where the two pieces of wood meet, in the center of the guitar there is just the SLIGHTEST difference (for about 2 inches)...one is higher than the other.... almost non existant...but you can feel it with your finger.

Trying to figure out if i should contact the seller about these (sold in 'almost new' condition) or whether these are no big deal things....

If it's just cosmetic, I could care less, but if I'm going to be paying for this later, would like to deal with it now...


Thanks all
Title: Re: Problem/Question...?
Post by: Ratishna on October 12, 2005, 04:02:27 PM
It probably isn't a problem.  BUT!  I would probably not be happy with it.  It sounds like the guitar was dry at some point in time.

E. Shoaf
Title: Re: Problem/Question...?
Post by: rwhitted on October 12, 2005, 04:06:31 PM
I agree with Shoaf. I doubt seriously it left the Holy Ground (Larrivee factory) with those flaws.

Does Larrivee have factory authorized technicians around the country like Martin does?
Title: Re: Problem/Question...?
Post by: drathbun on October 12, 2005, 11:17:34 PM
The back problem is probably cosmetic but in combination with the neck problem, they might be related. The neck heel lifting is an issue in my opinion. Check your neck angle to be sure the neck isn't sinking into the body. Put a straightedge, edge side along the fretboard and slide it down to the bridge. Does it slide just over the top of the bridge or does it run into the thickness of the bridge? It should slide perfectly across the top surface of the bridge. Low neck angle combined with a raising heel means the neck is sinking (has sunk) into the body. What is the action like at the higher frets? It might be that this guitar has been dehydrated or subjected to heat.  I would take it to a guitar tech to examine the neck heel issue.

Anyone else?