I've been thinking about using a mic through my acoustisonic jr amp for my guitar but it seems that most need 48 volts phantom power to operate. From what I have been able to find the amp only has 15 volts. Anybody else run into this and is there a soultion for it? Thanks
You need to buy a 48 volt phothom power unit.I bought mine a long time ago I think there around $100.
Gday mate,
Some small diaphram condenser mics take batteries, which can be a handy feature when no phantom power is available. I found that running condenser mics through acoustic amps was not worth the trouble, I struggled to get a decent sound. Same can be said for running Vocal mics through an acoustic amps second channel. Nothing beats a good quality PA for both in my opinion. Some mics also state that they'll run on anything between 12-48v? You could also run through a small mixer to get your phantom power. Are you going to blend the signal with a UST or some other pickup or just go through the condenser mic? Maybe look at the dual systems available, a blend of an internal mic and a UST or soundboard transducer.
Cheers, Scott.
If you own a condensor mic that requires 48V phantom you may need to buy an adaptor or preamp that supplies that level of voltage.
Many Audio Technica mics (AT3031, AT3032, ATM33A) will operate on 11~52V phantom, and sound very good on acoustic guitar.
Pretty crummy that Fender chose to put just 15 V phantom power in the preamp.
There are plenty of little mic pre-amp units you can buy that will supply the fairly standard 48V phantom power. In the under 100$ range, you can pick up one of the very reliable units from ART. Studio Projects makes a very nice unit, the VTB1 that you can get new on e-Bay for under $100. Probably the best sounding mic preamp in that range. Of course, there are much more expensive pre-amps, but you won't hear the difference through an amp. Makes more of a difference on recording.
Don't skimp on this part of your rig - a decent mic preamp can make a crummy mic sound pretty good. A crummy mic pre-amp will make just about any mic sound crummy.
I wouldn't rely on the 15V phantom for any condenser mic.
My next purchase will be a PA. I hear so many more positive replies on PA's vs my Fender amp.
Make sure that whatever PA you buy it has asignable phothom power and built in mic pre amps.Mic preamps are sometime called a trim or gain pot.
Thanks for the pointer unclrob. It's going in my book of "what to look for in my next music purchase"
It's the only way I will remember in three months. :wave
Also consider buying at least a 6 channel unit with 2 asignbable power amps this will give you room to add friends and with 2 asignable amps you end up with one for the mains and one for the monitors.
Thanks again unclrob, I appreciate your advice. :thumbsup