Main Forums => Technical Discussion => Topic started by: pickngrin on May 13, 2008, 09:15:19 PM

Title: Need Help with pinless bridge saddle
Post by: pickngrin on May 13, 2008, 09:15:19 PM
Does anyone know what would be a good height for the saddle on an old Sovereign with a pinless bridge, after a fresh neck reset. Is it the same as a pinned bridge with 3/16" being a good height?

Also, the saddle slot is only 3/64" deep so should the depth be lowered to accomodate a taller saddle?

Below is a pic of the bridge in question, before I removed the neck.

Any help, greatly appreciated,
pickngrin

(http://i49.photobucket.com/albums/f266/pickngrin/SoverignBridgeSaddle.jpg)
Title: Re: Need Help with pinless bridge saddle
Post by: Danny on May 13, 2008, 09:58:33 PM
I have an old Sovereign and I cut the slot larger to allow a Gibson style adjustable saddle. But mine is a mustache rosewood pinned type. These Harmony's didn't have the greatest saddle setup from the factory. So that's why I chose an adjustable, then I made a bone compensated saddle to fit in the slot. It worked out well for me because I just didn't want to lose that nice rosewood mustache bridge.
           Even though you have had a neck reset the Ladder bracing will allow the top to become "pregnant". If yours is a little to domed looking you may just need to fit in a saddle and see how it works and then make a new one or adjust the one you have tried at first.
           Of course I'm not a Luthier, but I do find ways to make my gits sound better or look better (most of the time)
If you can buy a pre-made compensated saddle (All Parts Tusq) they are less than $10 and you can make a trial run or two with them.                               Looks like a nice top on your Sovereign. Take what you want and throw the rest away of what I have said. Let us know how it turns out and I'm sure I'm not the only one that would like to see a full picture of you guitar.    Danny  :donut :coffee
Title: Re: Need Help with pinless bridge saddle
Post by: pickngrin on May 13, 2008, 10:41:49 PM
Danny, thanks for the info. Here's a pic of the Sovereign, I removed the neck today and I'm trying to decide what saddle height would be best and if I should deepen the slot with a straight edge wrapped with sandpaper. I know it should be routed with a jig but ya gotta use what ya got.

Mustache bridge huh? We wouldn't mind seeing that one either.  :smile: 

(http://i49.photobucket.com/albums/f266/pickngrin/IMG_0385.jpg)

Title: Re: Need Help with pinless bridge saddle
Post by: Danny on May 13, 2008, 10:59:43 PM
This one is just like mine and I already have the picture on file, this one has had a much wider saddle installed.btw I use a dremel to enlarge slots, I've done O.K. so far. But I won't go near my LSV-11 with a power tool.
                          This is a Fender Sovereign, It has Fender tuners, 3 to aside and a Fender logo on the headstock which matches th screwed on pickgard.
                           Does this make it "Boutique"...just kiddin folks

[attachment deleted by admin]
Title: Re: Need Help with pinless bridge saddle
Post by: jeremy3220 on May 13, 2008, 11:04:41 PM
It depends on the height of the bridge, normally you want about .5" between the low E string and the guitar top. I don't know anything bout that guitar though.